Gday all. I need the use of a rotissery to suit bay. Happy to pay for it. I have to roll on it's side to fit the chassis boxing to it for the midmount engine & transmissions between. Gympie & goldcoast. Be home Monday. If you can help please pm me
Ernie

G'day all just bought a tilta tech tilting cradle that will tilt up to 1750kg vehicle it is powered by electric drill to lift it. after I have used it on ECLECTIC it will be available for hire between sunshine coast & gold coast
ernie

G'day all. This the lifter I have obtained. once I have finished with it I will be hiring out to members of the associated clubs. at a yet to be determined reasonable cost.
ernie

I thought kombis were closer to the early 2000kg's??

Decent looking system though? and I am sure there is a bit of safety margin in the sizing of the units too.

Hey Ernie, i'll be looking for something like this in the next few months aswell for my bus. where did you get yours from?

Gday Nils I just happened to mention to a friend that I was going to build something & he said I have anew 1 for sale needless to say I pick it up tomorrow the catch being its at the far end of a 40 foot container. I think theres something he wants out of it so I do the work he gets his stuff as well. but not worry I got a bargain. the kombi has no motor or transmission in it no trim so should handle that ok. t the worst I will drop doors off. If you only need short term happy to hire to members. I only need it because of bad back & arthritis so save laying on creeper to do the under floor welding etc
ernie

I want to clean and paint the underside. while i have done it before by climber under there all suited up, its not something i plan to repeat.

I can imagine it would only take a couple of weekends. But you are nowhere near me