finally got it from newcastle off a member of this forum.

looking for driver side floor pan - need to weld in an un-rusted one
should i just use metal from bunnings?

and a pipe between the air cleaner and the body.

get the carbs balanced, and she'll be rockin'

I wouldnt recommend buying steel from bunnings its dear as poison and it depends how big an area needs to be replaced, you may need to source another floor to cut from.

Gotta find a replacement floor pan then.

Are there any photos getting around of a floor pan replacement, genuine or not? Doesn't have to be type 3.

Cheers

I dont know how much money you wanna spend on your type 3... but you might find that if one side has gone the other side may be rusty as well.
Nice type 3 by the way.