How would one go about getting more width and height on the fenders of a notch to acommadate larger wheels and tyres. Not sure if i want to go the baja look or just widen the track and keep it low for a beefier look. Ive got no skills yet in fibreglassing but Can use a tig welder. My only thought at the moment is to use add-on guards like that on the torana slr5000 or some of the later 4x4's getting around. A bit of bog to meld the seams and a bit of cutting of the original guards etc. Tell me if iv'e got it wrong already.

THanks

Any advice would be apreciated

Richard

This is the look im talking about

How were these one made do you rekon?

[ Edited on 18-2-2007 by riverrat13 ]

here is one on ebay at the moment