Hi everyone,

Just wondering what all your thoughts are on rust converter?
I have a few areas on my ghia that have the pitted metal look happening. These areas are still nice & strong so am thinking that cutting out and replacing the metal may be a tad drastic, which has led me to look for a chemical solution.

Should I go for a rust converter and if so, which brand?

Should I buff off all the surface rust first before applying it?

And what do you guys recomend with regards to prepping after treatment?

Cheers,
Cam

i use REVAMP rust converter.. have so for the past 20 yrs and it works like a treat.. revamp + rust = dead rust..

Thanks for that, will look into it. How do you go about prepping the surface?

I found this:
http://www.theruststore.com/How-To-Use-Rust-Converter-W29C2.aspx 
But it's not really accurate with regards to if I take it all back to bare metal or leave surface rust (assume the latter) and then the preparation for prime & paint.