Okay I have four panels that I need to get made up.
Of course none of the fabrication place's are open until monday.

Also if any members on here do fabrication, I would be more than happy to pay a fellow vw'er to do the job. I could cut out the rusty panel and send it over as a template.

What I'm after is some info from a member because most likely some of you have had experience's with fabrication. In other words just a rough quote of what it would cost to get done in order to put my mind at ease

Panel one: Drivers side floor- I only need what is with in the red box.



Panel two: Once again- only whats in the red box


And Panel Three: I need two of these made up. Now I need the whole thing thats in the picture BUT I dont mind if it doesn't have the ridges with are marked by red boxes. If that makes senses. I dont mind if- Instead of the ridges (marked in red) I just have flat Panel.