Board Logo

VW Badge?
crazyfiggi - August 4th, 2003 at 09:31 PM

I was wondering if the vw badge from a split screen can be made to fit on to the front of an early bay window? If so how? And has anyone done it?
Thanks.


fish - August 5th, 2003 at 05:37 AM

yeah ! as long as you don't mind drilling a couple of holes in your bay!! fits easy. just does'nt look the part thats all. better off sticking with a smaller one.


pyr0 - August 5th, 2003 at 08:24 AM

hehehhe you could try double sided tape but i dont think it will last long


baybuscamperkid - August 5th, 2003 at 10:05 AM

the quick way - supa glu
the good way - if the pins are long enough, drill thru your buss's nose then tap a thread onto the pind and screw it in place so that no little buggers can nic it!


oval TOFU - August 8th, 2003 at 01:47 PM

You can use some foam double sided mounting tape from 3M i think (no i dont work for them...) I used it to secure my hood ornament

http://www.aussieveedubbers.com/forum/viewthread.php?tid=8976 

and it stayed there no probs.. just make sure the surface you are sticking it to doesn't have wax or polish on it... I renewed the tape about once every 9 months coz the knife was starting to sag a bit. but if its only holding onto a badge, then it should be fine for a longer period of time. (Weather and UV rays will still damage tape a teeny tiny bit....