Board Logo

would you replace these? [heater channels]
charlie - February 22nd, 2012 at 07:08 PM

hey everyone,

both heater channels have a rust hole on the underside near the A pillars.

would prefer not to take the body off at this stage.

can i weld a patch in or is it time to replace?

thanks for any advice

silver - February 22nd, 2012 at 07:12 PM

Ahh the tip of the iceberg!

charlie - February 22nd, 2012 at 07:21 PM

a can of worms?

LUFTMEISTER - February 22nd, 2012 at 10:03 PM

Pandora's Box :spin:

jamiesc - February 23rd, 2012 at 07:51 PM

do you still use your heater ?
and if it was me i would probley weld it pump a lil bit of fish oil in there until you pull it of

charlie - February 24th, 2012 at 05:51 AM

The heater cables have ben disconnected, but not by me, why do people do this?

jamiesc - February 24th, 2012 at 12:31 PM

Quote:
Originally posted by charlie
The heater cables have ben disconnected, but not by me, why do people do this?


because the heaters usually a have rust holes in them and they just take them of cause the heaters dont really work anymore

charlie - February 24th, 2012 at 02:16 PM

ok

thanks for the advice.

jamiesc - February 24th, 2012 at 10:35 PM

your welcome mate if you need any help or a hand if your in brisbane mate just inbox me and ill help you out

charlie - February 29th, 2012 at 03:40 PM

thanks but im in sydney, i might shoot you a pm if i get stuck with the work, cheers

jamiesc - March 25th, 2012 at 06:26 PM

no probs your welcome charlie :)