Hey there, looking I change from heater boxes to an exhaust with j pipes. What is the go with the tinware? AS41 case. The sled tins can't just
hang there (they previously attached to the heater boxes). So do I
1. Forget about the sleds ?
2. Find some industrial engine tin (has anyone got some ??!!)
3. Create a bit of additional tin to "seal" the air flow under the engine, in effect simulating the side of the heater boxes?
Surely this has been dealt with many times? I can't find
Anything on it here.
What would you do?
Hus
Some people leave them hanging there - but i've just forgot them 
Someone may correct me though ...
| Quote: |
I bought a set of these you could make some easy or use a heat reflective / shield from a wrecked late model car he has some good stuff get a oil
cooler Hoover bit and, a fan Venturi ring while your at it.
http://www.awesomepowdercoat.com/Industrial_Shields.html
^^^^ Was just about to post that link
recommend 