Board Logo

1600&1800 Kombi Bellhousing Dimensions
mackaymanx - March 15th, 2006 at 06:26 PM

Here is a little side project I've been working on to make some kombi gearbox mounts for my Manx.
My Autocad skills are a little rusty but the basics are there. Thought i'd share the dimension i've worked out to save other people the trouble and see if anybody disagrees with my measurements.

[ Edited on 16-3-2006 by mackaymanx ]

[ Edited on 16-3-2006 by mackaymanx ]

[ Edited on 17-3-2006 by mackaymanx ]

mackaymanx - March 15th, 2006 at 06:28 PM

P.S there's more to come

mackaymanx - March 16th, 2006 at 09:27 AM

This is the layout for the intermediate to main housing flange.

[ Edited on 16-3-2006 by mackaymanx ]

mackaymanx - March 16th, 2006 at 12:58 PM

Ok here are the overall lenghts, front mount, shiftrod and C.V. flange positions. Still struggling with my AutoCad skills but getting there. I have some dimensions for the type 1 gearbox which I'll post later. Can't find the width across the C.V. flanges, I know I worked it out just can't find it at the moment.

[ Edited on 16-3-2006 by mackaymanx ]

[ Edited on 16-3-2006 by mackaymanx ]

mackaymanx - March 16th, 2006 at 01:17 PM

C.V. flange widths are

Type 1 259mm

Type2 278mm

these were very tricky to measure hope I got them right.
Any feeback anyone?

mackaymanx - March 16th, 2006 at 04:33 PM

Engine to bellhousing bolt dimensions are incorrect will fixup and repost tonight

Done


[ Edited on 16-3-2006 by mackaymanx ]

MickH - March 16th, 2006 at 08:39 PM

Hmm...cant open the files...

mackaymanx - March 16th, 2006 at 09:44 PM

Sorry, you'll need a copy of AutoCad. I'll try to convert to another format, have to hunt around on Google

mackaymanx - March 16th, 2006 at 10:19 PM

Ok try the pdf files

mackaymanx - March 19th, 2006 at 11:51 AM

Here is the type1 front gearbox mount. I haven't included the locating spigot on the back, was concentrating on hole positions and thickness.