I down loaded the CSP product page for the shifter i bought and it has this bit of helpful info

1st & 2nd wont engage - move shifter base to right

1st & 3rd wont engage - move shifter base to the front

2nd & 4th wont engage - move shifter base to the rear

reverse gear can be engaged with out pushing/pulling the lock out - move shifter plate to the left


Wish i had seen this before

i went thro all that crap when i put my quick shift kit in

but when u think about the way it works its not hard to work all that out as its just pivoting on the ball so its the opposite direct to the gear position
but yes very helpful anywayz

-Joel

LOL I went through hell with my super trying to stop it going into reverse after fitting the bugpack one. No luck, then I tried it in my Type3. Still no blasted luck, at least it wasn't expensive. Perhaps the plastic ones are a little different