Has anybody ever looked at these kits? Would they be engineer approved in Aus? Cost versus benefit etc.
Cheers
Troy

There is a thread about them, do a search.
I want one.

http://forums.aussieveedubbers.com/viewtopic.php?tid=86431&page=1#pid907503 
http://forums.aussieveedubbers.com/viewtopic.php?tid=92819&page=1#pid867382 
http://forums.aussieveedubbers.com/viewtopic.php?tid=83910&page=1#pid781444 
try these

worth talking to a local engineer about it; also Das Resto Parts on the Gold Coast sells a similar kit from Red9Design so they would have a few things to add as well if you talked to them.

http://dasrestoparts.com.au/ 

They have welded spindles and the engineer that i use will not pass them, you need to have a front end fitted with the standard spindles, i also spoke to the guys at red9design and they use a 1500 beetle spindle that has had the steering arm machined off and a bolt on one fitted, i think you might have a problem engineering that, I asked both mendeola and red9design for the welding proceedure and the code that was used to weld the components and only red9 came back with the necessary paper work, you also can look at the eyeball engineering front end as it use's standard spindles.
http://www.eyeball-engineering.net/ 

Das Resto also does the Mendeola as well.

Yogie

Thanks All, I'll ring das resto for some more info. Cheers