Wondering if those roof chops where people have chopped out just the roof and left the sides, windscreen and rear window frames still in need to be engineered in NSW?

I guess I am talking a cheapy home done rag top, not a full blown convertible. I am guessing most of the strength is still in the vehicle therefore no need for engineers approval?

Am I correct? Thanks.......

It will need to be engineered as a lot of strength is in the curved shape of the roof.

It's just a sardine tin conversion Lee, it's only the sheet metal of the roof thats cut out, the side strengthening is all still there.

A friend owned one by Sunbug in the 90s, they are much sturdier than a full convertable.

Same design as the Mexican factory OpenAir Beetles.



Although most aus converted ones just have button on tops.

Tin top to rag top conversion does not legally require an engineers report. It is still a sedan vehicle. It is only if you convert a Beetle from being a two door sedan to a 'convertible' or 'roadster' that you need an engineers report. This is what I do for a job every day on cars, V8 conversion, 4 wheel discs, chop, convertible, coupe, stretch limo etc. I deal with engineers reports on motor cars based on the NCOP and VSB14 in VIC in the VASS scheme. Other states are similar.

It is a way to get a fun car happening for a budget price. Cut, chop I am always for it. You do not need an engineers report to do a rag top.

If there is no extra support put in place there would be a reduction of torsional strength, that panel has a lot of strength and removing it would comprosmise that as it no longer ties the two sides of the roof together.

I would be keen to see any photos of whats involved with a sardine top or if there are any kits around.
I bought a convertible and found the channels and other sections totally stuffed with rust I have a sedan body which is good but i really wanted the open top. Perhaps this IS the answer!!