Board Logo

911 into SplitScreen?
sorenluckins - March 14th, 2005 at 07:06 AM

Hi All,

Does anyone know where there might be a reference article or some information on what is required to install and modify everything to run a 911 (2.4) in a SplitScreen....?.... Im still looking for a split but have just been offered a nice 2.4E engine so am thinking of taking it... Just want to have a look at how much work is required for the swap..

Cheers....

57kombi - March 14th, 2005 at 09:14 AM

In Volksworld a few months back they ran a feature on a blue bus that had a 911 motor in it.
Had to fit the whole subframe from the Porsche.

Cheers
Dave

sorenluckins - March 14th, 2005 at 09:33 AM

Hmmmmmmmm, thanks......

Ill try to get my hands on that issue and check it out. Sounds like a lot of work though, I always thought it might be a myth that you could do the swap relatively easily........

Thanks again....

57kombi - March 14th, 2005 at 09:43 AM

Putting an early Porsche, a 356 motor is quite easy as it is basically a VW motor( 4 cylinder 1600), the later 6 cylinders will not JUST BOLT IN.

Cheers
Dave

wacked1 - March 24th, 2005 at 02:10 PM

there is a 2.4?? for sale in the sydney trading post for 1850

VWENVY - March 24th, 2005 at 02:18 PM

What about this motor into a '75 Bay!? Different problems no doubt, but this would have to be an easier task? Just musing...

wacked1 - March 24th, 2005 at 02:27 PM

VWENVY already done by a couple of guys one is up your way
cheers