Hi there. We are about to put a subi motor into our 76 bay, and a new gearbox. Just looking for some advice. If you have done it, what was the best thing you did and the worst thing you did???

Any ideas on costings or general advice would be really helpful too. We will be doing the conversion ourselves wiht the help of COR conversion kit.....

You may find reading this thread worthwhile

http://forums.aussieveedubbers.com/viewthread.php?tid=38417 

I would put the costings including gearbox at around $7000 if you do it all yourself.

Thanks Helbus......that is a great thread. Hope you are recovering okay from your incident. That thread will help heaps!

worst thing...mmmm, probably not getting the front cut to begin with. But that's not terrible.

best thing, finding someone to do the loom for me.

best thing to do

buy custom off roads package out of the blue bus
its done complete and ready to bolt straight in

ask dave
33564356

SAVE YOUR SELF TIME, MONEY, AND LOTS AND LOTS EFFORT
still diy but everthing is there

you can pull it out too so you can see where it goes


terry

good luck

Terry , what is the cost of the throttel body you have for the subaru > I was telling some one here about them . Have you a photo of one in a Manx ?

cheers seagull