I thought I would post a few pics of the alternator bracket that I fabricated and exhaust header that I welded. I think the welds look pretty good for my first time welding. I moved the alternator to the other side so I could still run the air conditioning. I still have to weld up a few holes in the intake manifold and relocate the vacuum line to the backside of the intake manifold. With the exhaust maniflod bolted up I have approx. 8" ground clearance. I plan on running a magnaflow or borla muffler. I was going to weld in the muffler right after the Y adapter then run the exhaust out the stock locations. The header originalyl came from a 1.8 Suby.

Thanks,
Richard

more pics

[ Edited on 23/2/2006 by flat_iv ]