Board Logo

argh... can't get the EJ on
72RSbug - May 8th, 2006 at 12:33 AM

had the EJ20TT on a swing axle box on my other pan, no problem.

Now I have a type 1 IRS box on an automatic pan and I keep having a 1cm gap between the engine and the box :cry

I can wiggle the engine left and right so the point where something is holding it back is in the center.

Already tried it without the clutch guidance tube and same problem. Als tried turning the crank slightly with each turn.

What to do next?

1303Steve - May 8th, 2006 at 12:34 AM

Hi

Have you tried backing off the clutch cable?

Steve

72RSbug - May 8th, 2006 at 12:39 AM

The pedal set is not yet mounted on this chassis to there is nothing pulling the clutch lever.

seagull - May 8th, 2006 at 12:49 AM

where are you , gee I ask this a lot of times

72RSbug - May 8th, 2006 at 01:11 AM

Quote:

where are you



I live in Belgium.

I've measured the length and diameter of the gearbox shaft and it should fit. Think the bearing where the gearbox shaft sits in the flywheel might be the problem (I just put a plastic clutch allignment tool in it and that was a very tight fit.

seagull - May 8th, 2006 at 01:14 AM

not this guy ?

seagull - May 8th, 2006 at 01:15 AM

who made the adapter kit for you ?

72RSbug - May 8th, 2006 at 03:36 AM

nope, mine is this one http://www.cardomain.com/ride/844382 

My adaptor plate is from Kennedy engineering