I have two Nissan SR20 n/a front wheel drive low k Jap JDM motor here .

One has done less than an hour running ( as new )
The other has been in a road car in japan car was crashed motor is in good cond


& there up for grabs $

These make 140 hp at the wheels as my mate here has one of the same shipment in his ride .

How many of these $$$$ things

& do they fit under the std height rear tray in a bay Kombie???

cheers

Tell me the crank center to the under side of the tray & I tell you .

center of crank to top of motor 430mm
back of motor to pully 500mm

140 hp .

No need for sump mods very flat & you can buy a super sump for $200.00 for them

New motor $800.00

motor been in jap car $550.00

last two I have

Thanks man, it`ll probly fit by the sounds of it, but i think i`m going to put my old alloy V8 into her instead, looks like i can legally do it now :-)

Seagull, is there an adaptor plate conversion for these like the subie motors if I was thinking of putting it into a Bay Dual Cab?

Yes there sure is John at volks conversions QLD has stock

This would be a very good conversion , the sump is short & there is many bolt on parts .