I am putting an aftermaket O2 sensor on the buggy, and was wondering what wires go where
On the new sensor I have 2 black and a blue (instructions say black is temp, blue to computer), so what wires do I join these up to on the engine loom?????


Mat

Matt send an email to Buggy Brad as he should know of the top of his head or give him a ring @ COR

A four pin plug with three wires in the harness. BW (blue white) wire to ground,
YR (yellow red) +12volt from ignition relay, white shielded wire to ECU.



[ Edited on 27-2-07 by lexm ]