hi all have a little question for all the people that have done this conversion, more to the point people that have got the cor wiring loom. i have some pictures of some plugs that i'm not to sure about where they go. what i'm thinking is that the plug with 5 is maybe the O2 sensor? and not real sure what the others are.

Going to e-mail COR tommorow with the same question cuase they are pretty helpful but so are you guys

cheers
Andy

[ Edited on 1-8-2007 by ananelson ]

the next bunch of wires,

Top one's MAF connector - Mass Air Flow

Bottom ones:
Black - ECU read memory connector
Green - ECU self test connector

Here's how to use them:

http://weidefamily.net/VANAGON/ 

Click on Vanagon Project
Click the Engine-I tab
Click "Wiring" tab and its "Idiots Guide to Subaru EJ ECU Codes" & "Table Listing of Computer Codes for the Subaru Engines"

Thanks for that going through your webpage right now, i think that i have the wrong air flow sensor cause mine has only 3 points on it? will call subaru and see what there service techs say?

It's not my site, just very informative IMHO. Personally I learnt a lot from Brent's site.

I'd bet a penny to a pound (dollar x2) that loads of others have too.

Spread the word, appreciate the "little guys"