Finally got my arse into gear and started nailing this beast back together.For those who don't know the old floorpan went a weeee bit rusty and
basically fell to pieces. Started last Wednesday and hope to drive it to Brisbane at the end of this month.I work better under pressure.......
[Edited on 11-10-2004 by Mick H]
[Edited on 14-10-2004 by Mick H]
[Edited on 22-10-2004 by Mick H]
[Edited on 24-10-2004 by Mick H]
[Edited on 26-10-2004 by Mick H]
[Edited on 28-10-2004 by Mick H]
[Edited on 9-11-2004 by Mick H]
.....
[Edited on 12-10-2004 by Mick H]
[Edited on 12-10-2004 by Mick H]
......
[Edited on 12-10-2004 by Mick H]
.....
[Edited on 12-10-2004 by Mick H]
....
[Edited on 12-10-2004 by Mick H]
Damn...young bloke just woke up...will post pictures tonight...
are you moving to Brisbane at the end of the month or just coming down for a trip?
Also,
Can I suggest posting your pics in your Manx Club gallery:
http://www.netspot4u.com/~manxclub/gallery/AS0051
And then linking to them from here. Means the piccies will be bigger and saved for prosperity 
is that a steel or aluminium checkerplate? if steel, isnt going to be a bit heavy? whats going to run it?
Looking good. good luck with your time frame :thumb
It looks alot like a Brad pan. It's steel checker plate, 2mm from memory so not much difference in weight to a stock pan but much stronger.
MikeM...just coming for a visit.If you send me a password for the Manx site i will post there as well. The pan is a little heavier than the original
one but well and truely makes up for it in strength. Yes Brad made the pan and it was well made. It has a adjustable link pin front and IRS adjustable
rear end (CUSTOM OFFROAD) and 3 inch body stiffener as well. The engine is a 1916 Pobjoy(not steroid) and the injection kit is a redline webber with
48mm throttle bodies. I get to spend from 8 till midnight working on it so I've decided to pull me finger out and get it finished!!!!Will post more
pics nightly. Hope to get the body on in the next 2 days......
[Edited on 11-10-2004 by Mick H]
...
....
....
....
Lookin' sweet (gunna need sandbags in the front to keep the wheels on the ground:P...lol)
clearance......
looking good :thumb
COOL.....
:thumb :bounce lol
Nice injection setup
Looking good :thumb
hey man lookin sweet!! See ya got the stubs already and do you guys run alitte bit of camber on the front at all? Can ya bend the to arms to pull some
camber like with the balljoint?
alex
Looking good mate.
Whats the injection setup like ? Was it expensive ? Just gathering ideas. If you don't mind me asking....
Looking good.... I would hav pics of mine but have been to busy dreaming up design ideas for some guys kombi :>
| Quote: |
Be nice to that Kombi Brad or ill be stalking you !!!! I know where you live
Sat the body on tonight to have a looksy......BLOODY HIGH!!!! A lot higher than it used to be and it is set on the lowest settings....hopefully it will sink down a bit when my fat arse drives it around a bit....
....