Hey y'all,

I'm still looking at that buggy (listed her under another post) and hope if all goes well I'll pay a deposit tomorrow, if its still there. A question though....

The dashboard that is on it (not wonderful), that would have been an add-on, yes? The fibreglass would stop at, like, the top of the dash (eg at windscreen level) and then I assume a frame has been built underneath here to hold the steering column and the dash?

Reason I ask.....he's made the dash too low, either that or the seats point up too high. I haven't driven it yet but sat in it and my legs scrape on the dash, I don't know how I'll go yet with the pedals.

So...I assume I can do some minor work to cut the bottom off the dash? Is it possible to lift the column up a bit, or do they have to stay in the one position?

yeah u should be able to lift it as they have to with buggies and bajas when the put a lift kit on
they are after market seats can u move the back as the would be highter the standed other wise u will have to fix the dash and wheel
looks

This is the J&S dash shape, minus all the holes

So, does that mean that dash is under the one on the car? Will have to look at it, hopefully should be easy to make more room there.

The speedo looks to be in around the same place. with any luck they have just put a bored over the top