Board Logo

drop spindle camber
Lachlan VL - July 7th, 2013 at 05:22 PM

Hi guys going to get my drop spindles pressed so I have some canber on front wheels about .5 degrees just wondering how much does it cost to get somethin like this done.

mactaylor - July 7th, 2013 at 05:57 PM

normaly bend the top arms not the spindle.

Craig Torrens - July 7th, 2013 at 06:02 PM

normally fit offset (aftermarket) eccentric first........that will give you around 2.5 deg neg. If you then want more neg, bend top arms as said by mactaylor.

Lachlan VL - July 7th, 2013 at 10:10 PM

Thanks guys only lookin for .5 degrees would anyone possibly know wat it roughly cost to bend top arms

Sides - July 7th, 2013 at 10:45 PM

If you only want 0.5 degrees neg then all you'll need is the camber eccentrics, like Craigy has said.

If you definitely want to bend the top arms then not too difficult to do yourself - I did mine a few months back, and should be well within what you and JVL capable of.
http://forums.aussieveedubbers.com/viewtopic.php?tid=100412&page=1#pid938509 

:tu:

Lachlan VL - July 7th, 2013 at 11:11 PM

Cheers ill have a look into the ecentrics and better talk to.the old man

Craig Torrens - July 7th, 2013 at 11:20 PM

The stock VW eccentrics will give you .5deg neg.

Talk to your old man about bump steer !!!! :spin::smilegrin::no:

Lachlan VL - July 7th, 2013 at 11:51 PM

Lol i might upset him