Its been awhile since ive posted on the fourm so give you a bit of an update on what im up 2 im currently overseas at the moment and wont be back till the end of the year but i have want to show off my new motor waiting for me back in aus ready for my german looka..
combo 2276
cb 044 mini wedge port
cb crankshaft 82mm
wisecos
fk87
berg rockers
48idas
scat rods
10.5
a lot of time has been put into this combo massive thanks to dave butler for all his time i think over 70 hours was put into this engine cant wait to fit it into the car..

Nice dude. Bet you cant wait to drive it.

Wow! That looks jus.........hang on a minute, I have to wipe my chin.

Sounding like a good thing. I spy the larger washer/nut conversion on the case studs

If your rocker drains are 1/2 inch you could get one way check valves for them so the oil can't wash up them from the sump

What ignition you running?

you will have fun with this baby......

Ill be running msd 6al with cb mega spark dizzy

Is this going into a circuit race beetle?

looks good....have you done some port work to the exhaust ports, or is that how the come from CB ?

Yes its going into my 1303 circuit car and the ports have been cleaned up ..

What kind of power do you expect?

Man...... the last motor in there rocked!

This is going to be one impressive Super

Not sure of the power but i would hope around the 150hp at the wheels with really good pick up..

For circuit work Steve, u can't go past Stan Pobjoys Sump, I highly , highly recommend u put one on. If you want to still up the oil capacity a little, i put an RX7 oil cooler above my gearbox, fitted perfectly bolted to the underside of my parcel tray , from memory it took 1.5 litres & I just couldnt' cook my engine no matter how hard I tried.

Jak