Aussieveedubbers - Powered by GaiaBB

Cylinder shims ??

AdrianH - June 29th, 2005 at 08:28 PM

Does anyone grind cylinder shims over there ? I have tried locally, but cant seem to get anyone to do them right. The last .060" bugpack ones I got were .006" difference between the thickest and thinnest.
Im prepared to pay for good work !!

1303Steve - June 29th, 2005 at 08:37 PM

Hi

What size bore?

Steve

AdrianH - June 30th, 2005 at 05:14 AM

94 and 90.5mm. I would like .065" in the 90.5 and yet to confirm the 94s...

56astro - June 30th, 2005 at 10:01 AM

Call Stan (or Ruth) Pobjoy, near Coffs Harbour - 02 6654 3694

Arguably the best in the land.

2443TT - July 8th, 2005 at 02:34 PM

I got my spacers from cb performance. 0.230" ones, and the 0.030" shims came from there too. All my deck heights came up to within 0.002" of each other which is acceptable. about 0.04 variation as far as the CR calculations go...