Hi All,
As I have finished my intakes and if anyone wants to check them out they are here:
http://forums.aussieveedubbers.com/viewtopic.php?tid=31777&page=5
I know some of you dont venture much further than this section!
The injectors aren't on the angle I set out for them to be on as i wanted them to squirt down the ports some more but due to space and the bosses
protruding into the post and not enought meat to take out this is just how they ended up.
T54
[ Edited on 13-11-2006 by Turbo54 ]
that link didnt work 4 some reason
Worked OK.
Lookin' good!!
worked for me to.
classy work...well done T54
Looking good!!!!!!!!
nice work it looks like your taking your time.
Can I please be the one to change your plugs, especially no3.
Are you going to cut the weber holes on the side of the car for access?
Sure you can change the plugs, yes i am going to cut 2x30mm holes on each side and put plugs in so I can have access to the sparkplugs.
Yes it's taking time and $$$ and as i do all the machining and grinding etc but cant weld i have to wait for a mate to get time to do it. i wish I
had your skills. Onto the muffler next.
T54