Has anyone ever installed an after market system from
http://vintageair.com
? Any photo's would be appreciated, different ideas, mounting and venting solutions.
Cheers.
My friend has just installed vintage air in his Chev. the quality of the kits is impressive. If you dont find a solution from these guys i would be surprised.
Hi
fitting Air con to a beetle isn't as easy as any other car...
engine is in the rear..
condenser in the front of car....
Compressor is in rear of car....
cooling unit under the dash.... [??]
so its unlike the majority of other cars...
Lee
Yeah, cheers lads, i understand the complexity of the issue. Im putting in an Ej20T into the bug, so I've already got the compressor and the
condensor, it was more about how positioning of the actual unit, weather people had put it under the dash in the car or removed the glove box, or put
it behind the dash. also how people have vented the system, either by using the factory vents or custom ones.
My origional plan was to use the aircon unit out of the WRX front cut, and the aircon controls glassed into the dash. But when you put the unit,
(header, condensor and fan) under the front, you see how big it is. So I think im going to have to go with the vintage set up.
Any ones imput is appreciated. Thanks.
Check out industrial vehicle/forklift/tractor units, too
Also have a look at some of the newer micro cars, they have bugger all room to fit them in so could be a good swap
Quote: |
sorted! :thumb