Board Logo

Splitty Type I extractors/heater boxes/muffler - price drop to $300
Dasdubber - December 18th, 2012 at 11:04 AM

Hello

I have an exhaust system removed from a 2160cc type I motor that was in a splitty. It is one of George's stainless sidewinder repro headers (~$550 new) that has been modified to fit behind the rear valance, plus standard heater boxes (~$300-400 new) that have had flanges welded on to suit the header, and a custom muffler/resonator setup to take a bit of the drone out of the engine exhaust (~$300 in parts and labour).

Obviously the system is used (had around 10 months of usage) before being replaced with a CSP system.

Location: Burleigh Heads, Gold Coast (can freight at buyers expense)
Price: drop to $300 ($200 firm for the header and muffler minus heater boxes)...can't go any cheaper, will keep it for any less

Cheers
Al
PM or email me on al@dasrestohaus.com.au

http://i10.photobucket.com/albums/a145/Dasdubber/Sale%20Items/exhaust1.jpg
http://i10.photobucket.com/albums/a145/Dasdubber/Sale%20Items/exhaust2.jpg
http://i10.photobucket.com/albums/a145/Dasdubber/Sale%20Items/exhaust3.jpg

Dasdubber - December 20th, 2012 at 07:59 PM

price drop :tu:

cam070 - December 21st, 2012 at 12:58 PM

What size are the header tubes and what size engines would it be suitable for?

Dasdubber - December 22nd, 2012 at 09:08 PM

I'll have to check header size but from memory around 38mm, bigger than standard. Will be a bit over exhausted for 1600cc but will still work, up to mild 2110 (no good for high comp and huge valves etc)

Dasdubber - January 2nd, 2013 at 02:05 PM

Yep 38mm outside diameter header size.

Price drop to $300. Will have to keep it for any less so this price is firm, cheers. Al

Calcool - January 6th, 2013 at 09:20 PM

Hi Al,

Would it fit a 68 69 Lowlight???

Cheers

David