Board Logo

Square rear end GONE
donn - January 29th, 2013 at 06:14 AM

Further into the cave clean up and there it is, complete rear end with drive shafts, I was going to make a trailer just like your old mate Jeff but it's not going to happen so out it goes $100 plus post :lol:

donn - January 29th, 2013 at 08:33 AM

no body work, pics by email if required. :yes:

Special Air Service - January 29th, 2013 at 09:31 AM

you have a PM Donn

donn - January 29th, 2013 at 10:45 AM

Sent with note Brenden

donn - January 30th, 2013 at 08:01 PM

need the room, too good to dump:tu:

crazyfiggi - January 31st, 2013 at 09:42 AM

Is this the complete IRS rear suspension?
Alex.

donn - January 31st, 2013 at 09:57 AM

See the second post re email.

donn - January 31st, 2013 at 10:50 AM

Sold and holding till the !!th
Thanks
Don

donn - February 7th, 2013 at 11:32 AM

Gone, thanks Craig, good to meet you.

Craig Torrens - February 7th, 2013 at 05:30 PM

Cheers Don, good to meet you too :tu:

Now its time to turn my 74 swinger beetle into an IRS bush beast :D

Klaus - February 7th, 2013 at 05:32 PM

want to sell your swing box craig ..ab code $100 u can keep your brakes

Craig Torrens - February 7th, 2013 at 05:47 PM

LOL, a rare 4.375 diff ratio box is worth a tad more than $100 !

I will keeping the gearbox and converting it to IRS.

Klaus - February 7th, 2013 at 09:16 PM

I've cornered the market have 2 or 3 of them , rip em out n put 3.88 in :)

Craig Torrens - February 7th, 2013 at 09:21 PM

how about I swap you my 3.88's for your 4.375 ones then.......although I already have 4 so probably don't need any more :yes:

Klaus - February 8th, 2013 at 06:42 AM

nope

Calcool - February 8th, 2013 at 09:07 PM

Was this a swing axle back end? If so do you want the suspension frame?

Cheers

David

Craig Torrens - February 8th, 2013 at 09:50 PM

It was a late model frame.:tu: