Hello All,
Got a bunch of stuff. Throw me some offers if you are interested in anything. All located in Chermside. Can post combined items over $25 total
value.. (ie I'm not going to post a $2 part please I'd give it away
first )
Pics are in http://www.clubmans.com/beetle/forsale , their filenames
correspond to the item numbers below
101: 13x7 Deep dish smoothie wheel. Needs a cleanup, structurally good. $10
102: 14x7 Deep dish smoothie wheel x 2 (Second is identical in condition). Surface rust, structurally good. $25 pair
103: 2 x Wheel trims 14". Light surface rust in spots, $5
104: 1 x Smoothie hubcap. dint free, but need a polish to remove the surface rust spots. $10
105: Complete 1500cc single port motor. Apparantely runs fine. 68 era I believe. "H1" engine number. Comes with extractors clutch and flywheel.
Ie. what you see in the pics. Will split up if people just need parts. Needs a degrease. As is $175
106: 2 x shifters.. one is shortened $5 each
107: Distributer and Fuel pump. Look OK. As is, as I have not tested them. $5 each
108: Brake master res $2
109: 8 "slot" Hella fuse block around 63 vintage. Later model 10 "slot" as well. 2 x interior lights, one with a chip in corner $2 each
110: Ignition switch / barrel. No key (oops) $10?
111: Fuel gauge #1. untested $20
112: Fuel gauge #2. untested $20
113: Speedo 80Mph model - Clear needle. 1960 model. untested. Cleaner than it looks in the pictures, can take more if required $65
115: Wiper SFW with frame etc. Still 6V I'd presume. Untested $40
116: Wiper SFW motor only. Still 6V I'd presume. untested $20
117: Rear number plate light / holder. All complete. About 64 model? $20
118: Rear lights/lenses/surrounds from approx 63/64 model. Complete. $25
119: 180mm clutch and pressure plate. Lots of meat. $15
121: Plastic indicator switch / arm $2
Contact : Paul, 0437 437 746
LOCATION: CHERMSIDE NORTH INNER BRISBANE
{location required in adds]
How much are you asking for the jack?
Updated as per forum rules. Sorry about that.
Price for the jack ; $25.
Mate item 115, can you measure between the wiper shafts and let me know what the length is?
Am after a specific length one.
Cheers
I'll take all of the 13" wheel trims.
Please pm details.
Regards,
Matt.
No worries mate, its 405mm from centre of shaft to centre of shaft.
Thanks for that
too short - measured my car and I need to get one thats about 460mm from centre of shaft to centre of shaft
i went to have a look at this site and my puter nearly had a coronary and didn't want to go telling me that the site had malware potentially
infecting its every orifice..
so i like to be std free.. i'll pass
Thats odd. Its just a bunch of photos. Wonder if anyone else has had that?
And here's googles advisory, there have been no problems in 90 days.
Regards,
Matt.
Time to contact my IT guru. THanks guys. Anyone that needs a photo of the above goods, please send me a PM and I'll email you the photos.
Interesting at the last time it found something bad was Feburary.
Prices adjusted. Throw me some offers guys, need the stuff gone.
hey spectral, off topic but do you live up behind kedron/wavell services club and next to a house being built and you have a grey beetle and an orange kombi ?
Quote: |
Hey Josh, no idea mate if they will fit. My experience is solely with the earlier stuff. And no, I'm not going to the Fairfield nationals.. Going to the Gold Coast swap meet on Sunday, so I'll meet you there
Postage would be around $25. I just priced 6 wheel trims for someone to NSW and it was $30... but the hubcaps are a smaller diameter than wheel trims
so the box is smaller and therefore cheaper.
Quote: |
Quote: |
PM sent I'm Ferny Grove so can pick up easily