Hi guys, i cleaned out my garage today and i have a few bits i'd like to get rid of...

Bay kombi towbar - $50. Sold

1970 bug standard Fuel tank with filler neck -$40 sold

Tail light housings -$20 I think they might be for 50/50's but i am unsure.... they came with our buggy years ago and it had 50/50's on it. Sold

Pair of mazda 6 seats -$150 - offers?? We bought these from kuston kombi a couple of years ago to put in our kombi but never got around to it... they are one of a few modern seats that are low enough to bolt straight in and fit under the steering wheel of a kombi. They are presentable and you could just bolt them in and use them or get them recovered, i can help with recovery if required.

Mick
Mt gravatt east 4122
0439002870
or contact on here

...

text sent = re: taillight housings cheers

PM sent re tank Mick.

Tail light housings sold pending pick up.

Fuel tank sold pending pickup.

I found some more stuff...

Brand new Empi cal look window rubber kit 65-71 - $50

1970 standard bug bonnet ( ratty with oldskool pinstriping) -$50

1970 standard bug front guards (little rusty and dinged up) -$10 each

1970 standard bug decklid - $15

Wide 5 splitty wheel - $30. Sold

Brand new Bay window inner window scrapers - $20 sold

Oil bath air cleaner -$10

1500 cooling fan -$5

2 x smiths amp and volts gauges and 1 x unknown mech oil pressure gauge, all chrome surrounds would clean up good - $10 each. Sold

Brand new stainless eyelids bay window kombi / beetle - $20. Sold

Brand new Golf fuel gauge sender -$20. Sold

Gt 40 coil - $10

Genuine USA made Facet low pressure electric fuel pump -$30. Sold

...

...

...

I'll grab the bay window inner scrapers Mick. Bring em to dubs by the abbey and ill fix you up then.

cheers Brennden

All yours mate, see ya then.

Scrapers sold.

Pm sent on the gauges.

No pm received.

Gauges sold pending payment

Tow bar and eyelids sold pending pick up....

Hey,

Regarding the fuel pump. Can it just be plumbed in as pictured, then remove the mechanical pump, and away you go?
Or do you need to run a pressure reg also?

And lastly, are you willing to post?

Regards
Ben

Yes it can be plumbed I as pictured, it depends on what carbs you are running I guess... It's a low pressure pump set 1-4.5 psi I think. You really should run a reg to get consistent fuel pressure but I never did... I had it on my 1916 race motor with dual 44 idf webers. It worked fine. Yeah I don't mind throwing it in the post.

Ok cool, i'll take it

PM sent
Ben

Me take fuel gauge sender for golf. See you at abbey.

Cheers
Craig

Righto Craig. All yours.

Fuel pump sold pending payment

Golf fuel sender sold pending payment.

Bump... Can bring stuff to the abbey!

Bump. Offers on anything??

Bump

That's not a Splitty rim, It's early Type 3.
Is it still available?

Sorry mate, it's gone.... The new owner pointed that out to me when he picked it up.