In the next month I will have up for sale the beam out of my lowlight, as I have just ordered a 4 inch narrower beam and drop spindles for my bus.

This beam was completely re built by Luke Pell, before re installing it into it.

This consisted of new adjusters ($200)
New tie rods and tie rod ends
New centre pin
New ballpoints
New bushes.
New leaves from another beam.

Ball joints and trailing arms aren't included in the sale, everything else is. I have it set at halfway on the adjusters and it's pretty low, could go way lower. I run beetle wheels so have no issue with scrubbing.

It cost me $1500 in parts and labour. The beam is less than one year old.I'm chasing half that , $750 o.n.o.

Cheap lowering!

Obviously I have to wait for my beam to arrive from the states but putting it up for sale now so you all have time to figure it out.

Can't up load pics, but here is a link to my old business page where you can see the stance of the bus.

https://m.facebook.com/RusticBeanEspresso?id=203321536478938&refsrc=https...

Located in Coffs Harbour nsw 2450.

Please call or text me I'm rarely on here on 0412699715.