63 built 40horser.
This came in my 58 and the PO stated he drove it but I haven't tried to start it. I took it out to service it. Replaced the flywheel oil seal, all gaskets (fuel pump. gen stand, rocker covers) and oil cooler seals but have found a 36er for my car so this is up for grabs.
End float feels good and the compression is even when turning it by hand. Still 6 volt so 6v genny and coil. 009 dizzy fitted. Clutch fitted.
No cooling flaps or thermostat fitted
It also comes with the exhaust (not in the pictures).

It will need a repair to the inlet manifold - it had been glassed over when I got it but I was going to repair it properly.

$150
Located in Mackay but I will be driving to Brisbane soon so could arrange a deal to bring it down with me
Contact me via PM, Thanks

[img][/img]

[img][/img]

PM sent

Sale pending