So before I go to buying a new centre pull linkage for an experiment and see, would anyone out there have a one for a type one upright motor, would also try a hex but mods would be more extensive. In Bris but postage wouldn't be a killer if the linkage is not too dear.

If anyone had a spare lying around you wanted to get some money for.

Thanks, Cam - 0405 373 772

I used a type 3 linkage with a few mods on my 55 with a single port 1500 a lot of years ago,we ran holden strombergs with insulation blocks to get the height for the links to work. I have a couple of flat motors but it will be a while before I can organise any parts.PM if you can't get any bits before this.

They are cheap enough to buy a new set instead of using something that is worn out.

also hve t3 one or two centre bits cam

hi

i think i have what you need

i live Southside Bayside of Briss but work in and around Brissy

$35 and its yours

Cheers

David

0434 582 264