Gday

Does anyone that lives around Baulkham Hills in Sydney have a hubcap rivet tool that I can borrow for a few days?

Cheers
John

John when I worked at the dealership we had alocally made one it consisted of a piece of RHS with a locating stud and a pin with a recess for the rivet , the rivet sat in the clip and protruded through the rim, the stud located the rim & then you just pein the rivet until the clip is tight

http://forums.aussieveedubbers.com/viewtopic.php?tid=96078&page=4 

I just use countersuck allen head 1/4" machine screws with nyloc nuts n washers. Works a treat

Thanks people went down the drilling a bolt head and grinding the side as per d-train. Worked a treat.