Board Logo

WTB - REAR WINDOW BODY RUST REPAIR SECTIONS
kuta - November 18th, 2014 at 06:42 PM

Chasing a couple of cuts to repair these rusted sections on a 59 Beetle. Maybe someone has a body they could cut these out and send to me or I could pickup in Melbourne.

Thanks Sean.

kuta - November 22nd, 2014 at 08:06 PM

Seriously nobody out there? Just to cut out a small section enough to weld in there. Must be someone with a rusted beetle that is rusted out in all the usual places but not here?

Special Air Service - November 23rd, 2014 at 08:00 AM

I an most probably help you out if you can wait until late December early January ? would have to post them to you though..... but surely someone closer would have something for you.

Are you on facebook ? there might be some options on there for you

oldskoolguy - November 23rd, 2014 at 09:57 AM

Don't know if this helps but as SAS said there is options out there.
https://www.facebook.com/photo.php?fbid=10205576253632113&set=gm.88362685...
https://www.facebook.com/photo.php?fbid=10204730320285561&set=pcb.8847199...

bushed - November 24th, 2014 at 09:39 AM

got a 71 rear windo if any one can confirm same curve ??

also are the tp same as bottom ?? increases chances of a find...

kuta - November 24th, 2014 at 07:18 PM

Thanks guys for the replies. I tried the link to facebook but it didn't seem to work.

SAS I may have to take you up on your offer if nothing comes up.

Not sure about the 71 being the same.

Cheers

Special Air Service - November 24th, 2014 at 07:34 PM

no worries......

if you are on Facebook, you'll need to join a few VW groups to be able to get access to stuff.

try

VW Buy/Swap or Sell - Australia https://www.facebook.com/groups/714103505287478/ 

Aussieveedubbers https://www.facebook.com/groups/aussieveedubbers/ 

VW Restorers Australia https://www.facebook.com/groups/696877697020516/ 

join up then post your wanted adds on some of these.

Brendan

MR930 - November 24th, 2014 at 08:30 PM

http://www.justkampers.com.au/windscreen-repair-panel-2-piece-for-vw-t2-bay-1...

Something like this do the job?

roofchop - November 26th, 2014 at 05:39 AM

Check the radius, top and bottom (cardboard template)

If the same I have the top bits that will do the job! (upside down)

Cheers
Dave

kuta - January 6th, 2015 at 08:42 PM

Is your offer still available Special Air Service? I've had no luck finding these.

Grey 57 - January 7th, 2015 at 07:16 AM

Hi Kuta, I maight be able to help you with these body cuts. I have a 63 that's probably going to get the chop soon. I will let you know in a couple of days. I am located in Cowes Phillip Island Vic