This 1600 TP was built for my 15 window kombi resto using new and rebuilt factory parts ( no Chinese ). I registered it in December and have gone to some lengths to get this thing running to its full OG potential.
I ditched the new bristol carb in favour of a rebuilt 34 pict Solex (kit throttle plate bushes etc ) found and had an OG Bosch SVDA rebuilt, and it is now extremely smooth runs like a top NEVER uses or drips any old done 1,000 KLMs,


UNFORTUNATELY after ditching the reduction hub rear in favour of a IRS beetle box its not quite up to taking off when fully loaded in first gear. Fine 1 or 2 up but with half a dozen people it struggles although its great once going 1st gear loaded is a chore.
I am about to start a stroker engine build and as this engine is too smooth to strip for the tinware etc I could reuse so I would like to sell it as whole going concern Perhaps less the alternator fan shroud and fan? Will come with fan belt
It will be available in 6-8 weeks and I want $1600 it will cost me this much for a new case and tinware alone. The engine is in Port Macquarie but I can arrange for a Sydney pick up or Byron Bay Also happy to strap on a palet and drop of at Toll or other local carriers .
If there is any interest let me know otherwise she may have to get the chop. Mitchell

Sounds like a pretty good price

New Brazilian unleaded heads. new pistons barrels reused OG crank and case one bore over ( between .010 and .030 ")
Paperwork available.

PM sent

PM sent

pm too

Sorry to All especially Dicko but Its SOLD to someone who wanted to trade parts for my rebuild to good an offer to refuse. Mitchell
Thanks AVD also

Sorry to All especially Dicko but Its SOLD to someone who wanted to trade parts for my rebuild to good an offer to refuse. Mitchell
Thanks AVD also

Gota do what ya Gota do I guess. No worries.