I've got a pair of heater channel closing panels for a Beetle. 68> but could be used for earlier models too if not fussy about correct pressing pattern.

These came from a pair of new 68> channels that I drilled the spot welds out so I could modify the channels to be correct for a 56 and also ordered Hookys period correct closing panels. This I did because there were no decent early channels available in Oz at the time I needed them.

Anyhoo, as JK has new closing panels listed at $52 each then I reckon $25 for the pair is a fair price.

Here's a picture of them


Just PM me is easier or txt on 0415083360
I'm Mike and in NW Brisbane 4055

Righto, no responses so they'll be off to the scrap merchant in the next week or so with the rest of the steel scrap I have lying around.

Give me an offer if you want them otherwise they're paperclips

Hi mike sms sent, rich