Hi, got a few things I need to move. Facing up to the fact I'll probably never build another bug or engine, and I need to pay the rent. I'll add more as I remember or find them.

Reasonable offer to pick up or maybe I can drop off from Dandenong, Victoria. Otherwise postage will apply.


Web-cam 111 camshaft and gear. This is a good hot street or warm Kombi cam. Pretty high lift, but with a bit of care you can use it with HD springs up to about 5500 (I calculated a safe redline just shy of 6000rpm.) The ramps are reasonably kind to your seats if you check clearance regularly, but you should pull your heads and check them every 40-50,000km.

55A Alternator - $75 + postage?

Chrome Cylinder tins, DP

DP intake ends, pair

Set CB Performance Uni-tec stock size rods. These are based on stock rods, but better metal, a little clearancing at the bolts and balanced. I'll throw the bearings in as well - $60.00?

Set of aircooled reground and parkerised scat lifters. These have a little bit of surface rust, but any experienced builder will know that with a little phosphoric acid and light polish on the bore they will be good as new. $50.00

I also have complete engine hardware and gasket sets, including the good red crankshaft seal, racer spacer, cam and oil pump gears, hd lifter shafts, swivel adjusters, 8mm stud sets (I know, wrong size for the case,) pushrod tubes, quickshift kit, and I'll add more as I get things together and find completion of sets. For some reason I can only find 7 CroMo pushrods, for example. I even have a manifold for a progressive carb if anyone is interested.

got prices in mind ?

are you in WA or Dandnong? I'm in Moorabbin so not far for me to come to Dandy...

cheers, Ben

I'm in Dandenong. Sorry, better update my profile. If you're in Moorabbin and seriously interested, I suggest PM me, I'll give you a mobile number and you can make an offer.

Please don't be too harsh on me - I was sacked by DDS Moorabbin three weeks ago and I need to find a way to pay my rent to keep a roof over my 11YO son's head.

Graham here,
please email me at crsallora@gmail.com

interested in the crankcase

Crankcase sold.

I told you I was serious about any serious offer.

Pm sent

bugger - you were serious and I was too slow... tied up with cafe life and school holidays - well done on case sale...

Interested in some parts, please get back to me if you are keen to sell.

I did reply to messages, but didn't hear back, except for the guy asking about the alternator - sorry I haven't gotten around to weighing it, been a little busy.

Crankcase, P&C and crankshaft have gone. I will alter the above post.

still got the manifold ?? give me a bell on 0409213017

I'll take the rods if u still have them..
Fabo

Snap. I sent a PM about the rods this arvo. Haven't heard back though.
Cheers