Board Logo

For Sale - 1 5/8inch Scat Merged Racing headers (Extracters)
vwfastback - October 14th, 2004 at 03:45 PM

Hi,

I have a ceramic coated set up 1 5/8inch scat merged headers for sale. They have been used, and have approx 20 hours usage. These finish in a 3 bolt flange to attach to exhaust or stinger.

Comes with Lukey exhaust for the street and stinger for the track. Both are ceramic coated in black. (approx 15% cooler than silver)

Was good for approx 160hp at the flywheel. Same size will flow 260hp on an autocraft.....

Cost over $700 , for sale at $270.
Exhaust with stinger http://www.thesamba.com/vw/gallery/pix/173439.jpg 
Exhaust with muffler http://www.thesamba.com/vw/gallery/pix/173440.jpg 

James C.
Mount Dandenong 3767
0418312852

Postage not included. (Can transport to SA for the Volksfest)

Dannyboy - October 17th, 2004 at 08:24 PM

Sold if it's t3 ! Is it?

Dan

waltermitty - October 17th, 2004 at 09:00 PM

Im keen if its type 1 Ill ring. M

vwfastback - October 19th, 2004 at 09:55 AM

Hi Guys,

Mark called on the 14/10 and is inspecting them today. I will let you know how these have gone after then.

Regards,

James C.

vwfastback - October 28th, 2004 at 02:38 PM

Did not end up catching up with Mark.

These are still on the market. I am going to SA this weekend for the Volksfest. Can take them with me.

Regards,

James C.

BiX - October 28th, 2004 at 02:55 PM

What size heads would you recomend these for. Iam looking at upgrading motors soon so may be an option. Also what size is the flange? 2 inch 2.5 inch? will they fit inside the standard body work? and how do you reach the left head with the muffler where it is?

[Edited on 28-10-2004 by BiX]

vwfastback - October 28th, 2004 at 03:26 PM

I will measure the flange tonight. The flange is triangular, so I will measure from the apex to the middle of the base. I will let you know the size of the outlet as well. From memory it is approx 2 1/2 inches. I will confirm though.

They will run up to a 2232. I had them on my 2275. Send me your email and I will send through a couple of pics to show them on my car. I don't have any really good shots though. The flange is in the middle. The muffler that I have on it goes to the right, but you could replace that with a different on if you want.

I should note that this setup will fit on a type 1 motor. It is the same exhaust setup for the type 3.

BiX - October 28th, 2004 at 03:37 PM

thats what iam mopre interested in the outlet size. email drew.crossley@4siteco.com.au

BiX - October 28th, 2004 at 04:23 PM

does anybody know if they will fit a super bug?

vwfastback - October 30th, 2004 at 07:39 PM

outlet size from merged header is 1 7/8 inch.