Board Logo

New Microtech MT8 ....
boof2332 - November 3rd, 2004 at 12:28 AM

Hi All,

I still have the Microtech MT8 and hand held control unit, all brand new with wiring diagrams.

System was set up for a distributor pick up and rather than re-program it, which we worked out was not all that hard, another came up for sale exactly as I wanted.

$500.ono

matt
0416 115 993

71superbug - November 3rd, 2004 at 04:59 AM

this mt8. is it a microtech ECU?? if so im guessing its an old model yer? and could maybe work on a rotary?

let me know some details. as my kadrons and 1600 are going up for sale soon to fund the rotary conversion. and an ecu would be good. would this get rid of such boost limitations .etc on a standard 13bt ecu??


Anthony

boof2332 - November 4th, 2004 at 07:03 AM

The computer was the previous model to the Lt series out now. It will run to 20psi, although if you can find the program you can upgrade it to Lt specs which can run 30.
I was never going to run more than 18, so it would have been fine.
It should work on a rotary, would just have to fine tune with the lap top. It is dizzy engine?

Matt

Too Low - November 4th, 2004 at 09:04 PM

SOLD

boof2332 - November 5th, 2004 at 09:18 PM

Yes it is!

Thanks for the interst

Matt

71superbug - November 6th, 2004 at 05:41 AM

hmm. i might be interested in one of these fairly soon assuming i sell my kadrons/1600 and transmission.

it would be for either a rotary or a ej20t. is there an aftermarket one that works on both?? as i havent decided which one yet but will definately be one of each. even if it needs to get reprogrammed. just one that can work on both. :)

let me know of one. and how does haltech compare with microtech??

there is also motec. but they seem so expensive. any advantage?

Anthony

boof2332 - November 6th, 2004 at 09:24 PM

They will work on both, although my advice is not to buy a computer till the later stages of your project...get a surge tank/ new fuel pump and lines or a radiator and plumbing.

matt

71superbug - November 6th, 2004 at 10:32 PM

well radiator and plumbing was the first thing i was going to call.

anyone have any idea about using a falcon radiator?

Anthony.

boof2332 - November 7th, 2004 at 09:52 PM

Has to be a sealed radiator(no cap) Jak used a camira, I used an alfa 33. you first need to work out where you want to put it...measure the space, make up a cardboard template and go to a wrecker and start looking....

Matt

71superbug - November 8th, 2004 at 12:57 AM

i am to put it in where the spare wheel well is.

Anthony