Type 3 1600cc engine for sale, 2 years old, very strong, I also have the dyno sheets for hp @ the wheels, air fuel ratio & tourqe.
Owner selling as he now has a new 1641cc engine.
Come with carbies, air filter setup, fan on crank & alloy fan housing.
$500.
regards
Jak

jakriz@iprimus.com.au

Where abouts are you? I am looking for a 1600 kombi engine (just blew mine to bits). Whats the difference with type3?

Dave
dadams13@scu.edu.au

so tell use what kind of hp did it put out?

It put out 38hp @ the wheels, which Mike at CBB who dynoed it says is very healthy for a stocker. It sits on 70mph on the freeway quite easily.

I'm on the Central Coast , 1 hour north of Sydney.
I have no idea if it can go into a kombi? I'm sure that someone on this forum can answer that though.

regards
Jak

Can't say for sure, but the mount at the rear of the 1600 case is same for type 3 and kombi, which is the importent bit.

As for interchangability, all you can really use from type 3 is the long block and swap all tinware/fan/etc over to put back in kombi.
Not sure if flywheel is the same.
As you have both motor's it shouldn't be hard to swap all the bits over.

Thanks guys, but am lookin for a 2lt or 1800 now (have gearbox, so why not)................
Dave

Jak, you have email.