Ok, I have decided to upgrade a bit so heres whats for sale...

Heads 044- CB CNC oval ports, Bugpack valves, Remmelle retainers, Bugpack springs, berg collets. 42 x 37.5 with a 90.5 bore and .040" copper head gaskets. Also comes with a complete set of new valves, dual springs and retainers and collets (single groove CB stuff).

Cylinders and pistons - Berg 90.5s (B's), balanced, total seal second rings, berg circlips.
Manton chromolly pushrods - bit of a scar on 1 or two, still in use with the above so fine to use as they are.
Sig Erson 1.45:1 rockers (I have measured this) and cup adjusters...

I have used all this stuff for the last 1200 miles (12 months). For the lot $ 1600 NZ plus freight .Engine is still in one piece, will pull to bits if someone is serious.

Currently I am lifting .555" at the valve using an 86B cam. Springs were shimmed off the head so no scarring has taken place.

Will split for reasonable offers...

Around 1000 for the heads
Around 350 for the P and Cs
Around 300 for the rockers and pushrods