Have you a kombi 72 to 79 wreck ready to go to the crusher.
I am after the rear outer panel that holds the
left and the right rear tail lights.
I am good with a 7" angle grinder.???????????
The cut would start at the ..engine bay opening around
past the tail lights ..stop at the seam joint that meets
the rear 1/4 wheel arch panel.

I am making a 4' x4' enclosed box trailer with top and I want use the tail light panels to give it that kombi back end look.............sweet................


So ..... do we have any donors in Adelaide ???

Rays 76

go to u-pullit.
at elizabeth