Board Logo

WTD Inlet Manifold 1974 LBUG 1600
Kever - February 14th, 2006 at 04:55 PM

Looking for an Inlet Manifold to suit my 1974 L Bug 1600cc.

Has the single preheater pickup. Has a small vacuum outlet to the left leading to the Air Cleaner.

If you have one that is not blocked or rusted out .. and for a reasonable cost :) please let me know.

Many Thanks

Robert

Melbourne

killakornkobb - February 14th, 2006 at 07:00 PM

single or twin port? i think i have what your after, in melb also

Kever - February 14th, 2006 at 07:20 PM

Hi Damien,

Thanks for the reply,

My Bug is a Twin Port.

Regards

Robert

killakornkobb - February 14th, 2006 at 07:46 PM

i got the manifolds to suite a 1600 twin port, all good except one heat riser is rusted out. also got the carb i was running on the manifolds too

killakornkobb - February 14th, 2006 at 07:53 PM

my bad - i had a look outside, it seems when i had my manifolds changed to fit my weber, my mate ground thru the heat risers.. and theyre not seperate pieces like on the manifold for the weber:(

sorry pal, thought i had what u were after

Kever - February 14th, 2006 at 08:05 PM

Thanks for looking Damien :)

Robert

beerdoc - February 14th, 2006 at 09:05 PM

Let me check the garage

Give me a couple of days

Kever - February 15th, 2006 at 03:03 PM

Thanks DOC :)

Are there any other possibilities should DOC not have one?

Robert

beerdoc - February 21st, 2006 at 08:36 PM

Have failed you but have not exhausted all avenues

If you still needing I will keep looking

Craig Torrens - February 21st, 2006 at 09:08 PM

I have one but I am located in Sydney.