Aussieveedubbers - Powered by GaiaBB

** SOLD** For Sale VW Factory EFI Plenum/TB, intake runners, injectors and...

Euro_67 - July 4th, 2006 at 09:18 PM

Factory VW T1 EFI intake manifold and Aftermarker Microtech Digi 1 Fuel only computer and hand programmer.

Condition : Used in good condition

Location : Belmore NSW

Includes.............
* Plenum / TB Assembly which replaces generator / alternator stand
* tps switch, intake air temp sensor
* Twin port intake runners, injectors, fuel rails and aux air intake bypass valve
* Malpassi rising rate fuel pressure regulator
* Microtech Digi 1 fuel only computer, hand programmer, harness and manual
* Bosch electric fuel pump

This was setup on a 1776 with stock heads and engle 100 cam and ran well (map still resident in computer).
see photo of engine below with setup in place. Installation will require relocation of throttle cable through fan shroud to accomodate different throttle linkage position, and a new Type 3 TLE EFI head temp sensor (available from vintage for about $40.00) as I broke the cable off the one I was using. See additional photos.

$500.00 ONO

Plenum has been bead blasted back to aluminum. more detailed photos available if required.

Thanks,
Wayne.

[ Edited on 5-7-06 by 1964_Notch ]

[ Edited on 7-7-06 by 1964_Notch ]

Takhoal - July 4th, 2006 at 09:49 PM

u2u sent

Euro_67 - July 5th, 2006 at 11:36 PM

bump

noslug - July 6th, 2006 at 07:01 AM

Very interested. Does the microtech have a map sensing ability ? Or the ability to be expanded into this ??

email me at : adrian.hill@mastertrade.co.nz

Thanks

[ Edited on 5-7-2006 by noslug ]

crzbug67 - July 6th, 2006 at 10:41 PM

hi would you take $400.00 for it or swap for twin 40dcns and manifolds and geanberg linkage .

Euro_67 - July 7th, 2006 at 05:58 PM

Looks like its sold. If things change I will re list it for sale.

Thanks,

Wayne.