Looking for a rear valance/clip to suit a half-w lid. Want to make it so that it can be removable as wel so I need it from the engine seal back if possible.

I'm in Melbourne.

please u2u if you've got something

[ Edited on 8-11-06 by ruckus ]

I've got one that's still on a car waiting to go to the tip. If you get stuck, let me know by U2U. It'll be a pain to get off no doubt and it'll be expensive to ship, but if you want it let me know soon. We'll work out a price then.

Thanks.
Ross.

i have a good one as well on a 66 beetle i am wrecking at the moment but in the same boat..expensive to post..cheers.....vaughn

Not sure the 66 one would fit a half-w lid?


I assume postage would be a nightmare?

what year model is the car you want it for?

I just used the one on the car, unpick it and do a few mods, I can send you some pictures if you like, or you can come and have a look.

Nathan

Problem is it's going on the '71


Thanks for the offer though Nath. I've already peeped-out your pics heaps.

postage from 4650 less than $40 (Hervey Bay area)
i just dont have one atmo to help u out

not hard to cut off Ross btw

wrap it in rags and remember the big Warehouse Bag $2

Got one in Adelaide if u want it, already cut off. Can check on post if you're interested, might not be too bad if its just the apron with only an inch or 2 of the inner fenders so its pretty flat.

Sounds good to me. postage details u2ued. Thanks

you could also try bus freight, it might be cheaper.