Am selling my SIP 150Amp Mig Welder - It is approx 2yrs old. It was around $700 for the welder and $200 for the reg and mods.

The MIG usually uses the canister argon cans, but that becomes expensive so I had it changed and bought a reg setup ($200) and now uses normal BOC Cylinders. It runs both gas and gasless

This is a great little welder for anyone learning how to weld. I used it to build repair a trailer, make some benches and bodywork on the beetle. It hasnt done much work.

The welder requires a new hand piece for it to work (mate lent it and promised to fix but never eventuated) They are readily available from Glenfords.

It is surplus to my needs as I have access to free one and free ones always seem to work better.

It does NOT come with the cylinder- they are rented from BOC.

Call me if you would like to know more.

Welder is located in Milton- Brissie City.

Price $300.00

Ph 0417 070 661.

Peter

Regulators

Handpiece

Bump

Hey mate I sent you a u2u on the welder.... Am v.interested.

Cheers

Scotty

These messages must go via China or something- I dont have any messages.

Peter