Board Logo

Splitbus narrowed beam (caster corrected)
splitbusaustralia - May 17th, 2007 at 01:00 PM

Greetings all,

I have one more K&L splitbus narrowed beam available. New construction (not
cut and welded), caster corrected for lowered bus, new center pin, bushes
and adjusters.

$850 exchange.

I'll probably move to making as requested after this one.

regards

RobK

http://www.splitbusaustralia.com/beam_10.jpg

http://www.splitbusaustralia.com/beam_11.jpg

vsleepy - May 24th, 2007 at 08:01 PM

Hi Rob, is this for bushed or needle bearing arms?

splitbusaustralia - May 25th, 2007 at 06:26 AM

It's made for either. If you have 64-67 needle bearing
arms you do have to take the sleeves off the outer end
(the tube end of the arms are the same apart from this).

regards

RobK

[ Edited on 24-5-2007 by splitbusaustralia ]