Name - Brad
Location - Samford
Item - I have a complete set of 181 spindles and stubs. These will fit onto a Type 1 BJ front end and give you 3" of fully legal lift. The 181 front
end also uses heavy duty ball joints in a stronger configuration. These are the best way to give your ball joint front end a lift.
These are in good condition without scores on bearing / seal surfaces. Would need new ball joints.
Can supply new ball joints, disc conversion or heavy duty hubs to suit at additional cost if required.
Cost - $850 FIRM
Contact - PM
For a beetle right? I need some of these for my 74 camper!!! where do I get?
No such beast.
These are factory type 181
hmmm... any idea how much it would cost to get these to Perth... ?
SFA as a % of the purchase price.............
http://www1.auspost.com.au/pac/aus_parcel.asp
Brad
Check PM
Cheers
Joel
| Quote: |
Hi all
I got these off Brad, though since scored a Splitscreen Kombi 
and Baja is probably not going to happen for now 
Anyway these are up for sale again, description is below
Name - Joel
Location - Perth (Carlisle)
Item - I have a complete set of 181 spindles and stubs. These will fit onto a Type 1 BJ front end and give you 3" of fully legal lift. The 181 front
end also uses heavy duty ball joints in a stronger configuration. These are the best way to give your ball joint front end a lift.
These are in good condition without scores on bearing / seal surfaces. Would need new ball joints.
Cost - $850 + Delivery (only want what I payed for em)
Contact - PM
Bump