What we have here is brand new double rear light sections to house brake light and blinker as a weld in item to convert any tail light system into a double rear light system as used on early 60's busses.

These are accurately measured and laser cut, for precision, to not warp or bend the metal and to be exact as the originals for light fitting and look.

These are cut on a plate 16cm x 28cm out of 0.9mm zinc coated steel. All you have to do is cut this size plate out of your bus and weld this section in.

Measurements for light location on the bus will be supplied with the sections, so you know where to weld them.







Cost is $60 a pair including express postage anywhere in australia.

You can contact me by pm or email robert@kuch.com.au

Cheers
Kuch

And this is what they look like with lights.



These panels can also be purchased from Kombi Rescue who can supply the complete light assemblies, lenses, rubbers, screws etc as well.

Enjoy,
Kuch